CFRP Tendon Anchorage for Beam-String Structures: Structured Evidence Review, Quantitative Synthesis, and Finite-Element Assessment

Main Article Content

Fan Donghao, Aiman Al-Odaini

Abstract

Adequate anchorage is essential for the use of CFRP tendons in beam-string structures (BSS). CFRP tendons can develop high longitudinal tensile loads, but may have limited transverse and interlaminar load resistances. This research undertakes a structured review of publicly available evidence, describes and synthesizes anchorage results quantitatively, and develops a one-dimensional finite element model, to study bonded tendon anchorage. Different systems and their failure modes, models, and relevance to “BSS are analyzed. Quantitative synthesis is done on ratios and specimen results, and results are not integrated when they are judged to be different. Bonded tendon anchorage is modeled using the concept of elastic load transfer. In the model, a linear-elastic tendon is represented by an axial element and a shear element. The model is assessed for mesh refinement and length of the bonded element. According to the model, the length of the element beyond the bonded-anchored tendon need not be modeled. Several BSS-related experiments are reviewed, and a model validation strategy is proposed. The model is not validated using these experiments. The study demonstrates that a 5 mm CFRP tendon can be anchored in a BSS, but 7 and 9 mm tendons cannot be anchored using the considered solutions. The study proposes that modeling and design should consider diameters and pressure distributions and contact stresses between the anchor and the BSS. Findings are relative and specific to the models; they are not representative of a comprehensive 3-D wedge damage simulation.

Article Details

Section
Articles